![](\"http:\/\/www.spotswoodcomputercases.com\/images\/mining\/Octominer\/assembly\/Frame%20w%20just%20fans.png\")
<\/a><\/h1>\nParts<\/h1>\n
Attach a post to a short beam using a M3x20mm bolt and washer (the bolt is inserted through the short beam).<\/p>\n Insert two hex nuts into the bottom groove of the short beam.<\/p>\n Using the two hex nuts, attach two rubber bumpers to the post-and-beam sub-assembly via M3x6mm bolts.<\/p>\n Attach the second post to the sub-assembly.<\/p>\n Assembly another post & beam sub-assembly, but without the feet.<\/p>\n Assemble a third post & beam sub-assembly, with feet, but without the second post.<\/p>\n Using M3x35mm bolts, washers, and nuts attach a long motherboard support beam to the three sub-assemblies (the long bolt goes all of the way through<\/em> the corresponding holes in the motherboard beam and sub-assembly beams).<\/p>\n Repeat to attach the second (middle) motherboard support beam.<\/p>\n Attach the PSU support using M3x20mm bolts washer and hex nuts.<\/p>\n Insert 8 M4 hex nuts into the milled GPU support beam. To prevent the nuts from sliding out of the groove, “capture” them via two M4 Phillips head bolts.<\/p>\n Attach the GPU support beam using M3x14mm bolts washer and hex nuts.<\/p>\n Loosely attach the 17 hex standoffs to the frame using M3x20mm bolts. (TIghten the bolts after the motherboard is secured.)<\/p>\n Using M3x6mm bolts, washers, and hex nuts attach 6 aluminum PSU mounting “tabs” to the back of the frame (black plastic tabs shown in pic).<\/p>\n Insert 6 hex nuts into the grooves in the two fan support beams.<\/p>\n Attach the two fan beam to the frame via M3x20mm bolts, washers and hex nuts.<\/p>\n Using M3x6mm bolts, washers, and hex nuts attach 6 aluminum PSU mounting “tabs” to the back fan support beam (black plastic tabs shown in pic).<\/p>\n The PSUs are attached to the black plastic fan tabs with three #6-32 bolts and washers.<\/p>\n Fans near the front of the GPU brackets are attached to the frame via the 6 black fan tabs (the same tabs to mount the PSUs), along with M3x35mm bolts.<\/p>\n Fans at the tail-ends of the GPUs are attached directly to the frame via M3x30mm bolts and M3 nuts that are inserted into a slot in the extrusion.<\/p>\n <\/p>\n","protected":false},"excerpt":{"rendered":" The most up-to-date assembly manual for the Octominer frame is at: http:\/\/spotswoodcomputercases.com\/?page_id=9212 Parts Assembly Attach a post to a short beam using a M3x20mm bolt and washer (the bolt is inserted through the short beam). Insert two hex nuts into the … Continue reading <\/a><\/p>\n
\n<\/h1>\n
Assembly<\/h1>\n
<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/p>\n<\/a><\/p>\n<\/a><\/p>\n
\n<\/a><\/p>\n
\n
\n<\/a><\/p>\n
\n